TK MARINE GREY anti-corrosion primer 40099

ANTICO GREY

• High-strength anti-corrosion coating
• Rustproofing primer for preparing surfaces before finishing paintwork
• Excellent adhesion on all surfaces including slightly rusty ones
• Highly cross-linked resin that provides high resistance to thinners
• Compatible with all types of finishing paint
• Scratch and corrosion resistant (1000 hours in salt spray)
• Fast drying (can be recoated after 1 hour)
• RAL 7040 Suitable for light-colored topcoats
• 400ML aerosol can

Product information:

ANTICO GRIS is a solvent-based alkyd nitrocellulose primer, in aerosol form,

• ANTICO GRIS is a solvent-based alkyd nitrocellulose primer, packaged in an aerosol can,
• intended for preparing the surface before applying a finishing paint.
• It can be applied to all surfaces (test on plastic beforehand) and dries quickly.
• It is compatible with practically all types of finishing paint and does not flake.
• A single coat of dANTICO GRIS is enough to protect a metal surface from corrosion
• and allows for better adhesion of the finishing paint.
• Reference: 40.099

MAIN CHARACTERISTICS

• Rustproofing primer with excellent covering power, intended for the preparation of surfaces prior to finishing paintwork
• Can be quickly recoated thanks to fast drying
• Suitable for light-colored topcoats
• Excellent adhesion to all metal surfaces
• Highly cross-linked resin that provides high resistance to thinners and solvents
• Compatible with all types of finishing paints
• Very good scratch resistance.
• Excellent resistance to corrosion in a marine atmosphere (1000 hours in the
• salt spray test).

AREAS OF APPLICATION

• Used to protect ferrous and non-ferrous metals from corrosion

DIRECTIONS FOR USE

• For ANTICO GRIS to adhere perfectly, it is essential to degrease, sand, brush, wash, remove dust and dry the surfaces thoroughly
• Avoid painting when the temperature is below 5°C
• Shake the aerosol can upside down for 1 to 2 minutes; the ball will mix the solvents, resins and pigments
• Start spraying by moving the aerosol can, with the nozzle 15 to 25 cm from the surface, in an upward direction
• Spray in slightly overlapping strips and never hold the aerosol motionless in the same direction to avoid dripping
• To achieve good coverage, move from left to right and up and down
• Apply in thin, repeated layers rather than one thick, runny layer
• Wait 30 minutes between coats
• It will be completely dry after 12 hours
• Once the job is finished, turn the aerosol upside down and press the nozzle to empty the whole spraying mechanism. Keep under pressure until only the propellant gas arrives
• Clean the diffuser with white spirit if necessary